On a chilly winter day, you’ve just arrived home, and the first thing you do is turn on your wall heater. You set the thermostat to your desired temperature and then wait for the warm air to start blowing. But nothing happens. You realize that the pilot light must be out, so you search for instructions on how to light it. But even after finding these instructions, you’re still not sure how to proceed. Don’t worry – this guide will walk you through each step of the process safely and easily.
Let’s discuss the process of how to light pilot on wall heater
1. Turn off the wall heater by switching off the breaker that it is plugged into.
2. Find the pilot light. It will be a small, blue flame located near the burner on the front of the unit.
3. Follow the instructions that came with your wall heater to light the pilot light. There may be a special tool required, so make sure you have everything you need before you start.
4. Hold down the gas knob while you light the pilot light. Keep holding down the knob for about 30 seconds after the flame has ignited to ensure that it stays lit.
5. Turn on the breaker and wait for the wall heater to heat up to your desired temperature. Once it reaches this temperature, you can turn it off again by switching off the breaker.
6. If the pilot light goes out, repeat the steps above to relight it.
7. If the wall heater does not turn on after you have lit the pilot light, there may be a problem with the unit and you should contact a qualified technician for assistance.
Safety precaution when the light pilot on wall heater
1. Always follow the instructions that came with your wall heater when lighting the pilot light. There may be a special tool required, so make sure you have everything you need before you start.
2. Hold down the gas knob while you light the pilot light. Keep holding down the knob for about 30 seconds after the flame has ignited to ensure that it stays lit.
3. If the pilot light goes out, repeat the steps above to relight it.
4. Turn off the wall heater by switching off the breaker that it is plugged into when you are finished using it. This will prevent any accidental fires from starting.
5. If the wall heater does not turn on after you have lit the pilot light, there may be a problem with the unit and you should contact a qualified technician for assistance.
Conclusion
Now that you know how to light the pilot light on your wall heater, you can safely and easily get the warm air blowing. Always follow the instructions that came with your unit, and remember to turn off the wall heater when you are finished using it. If you have any problems, contact a qualified technician for assistance.
Frequently Asked Questions
How do you ignite a gas wall heater?
The first thing you need to do is locate the pilot light. It’s usually a small, red flame located near the burner.
1. Turn off the heater by turning the thermostat all the way down.
2. Find a lighter or matches.
3. Hold the lighter or match up to the pilot light and ignite it.
4. Wait a few seconds for the pilot light to start burning brightly.
5. Turn on the heater by turning the thermostat up to your desired temperature. The heater will now start blowing warm air!
Why does the pilot light go out on my wall heater?
There could be a number of reasons why the pilot light goes out, but some common causes are:
-The heater isn’t getting enough oxygen: Make sure there’s nothing blocking the air intake on the heater.
-The pilot light needs to be cleaned: Use a wire brush to clean the pilot light.
-The thermocouple is broken: This is a safety device that keeps the gas from igniting if the pilot light goes out. If the thermocouple is broken, you’ll need to replace it.
Can you leave pilot on wall heater?
It’s best not to leave the pilot light on for an extended period of time, as it can use up a lot of gas. If you’re going to be away from home for an extended period of time, it’s a good idea to turn off the heater completely.
Leave a Reply